English Support - Hardware > easyControl

EC4P to PC connection fails

<< < (2/3) > >>

Roman:
Softwerker59:
Hello,
Yes, I see COM port in hardware config. It has number 7.

Here is port config:
bps: 57600 (have tried others)
data bits: 8
parity: none
stop bits:1
flow control: none (tried changing it)

Config in "Communication parameters" is exactly the same.

ndzied1:

--- Zitat von: Roman am Februar 21, 2009, 18:15:49 Nachmittag ---ndzied1:
Thanks. I've got the manual. It says I can use easy800-USB-CAB to program ec4p.

--- Ende Zitat ---

We have never had luck with this.  We use EU4A-RJ45-CAB1 for setup.  Even not to hard to make your own by cutting standard Ethernet cable and soldering to DB9 connector...

Roman:
ndzied1:

Could you be so kind to show the pin-out?

Softwerker59:
Your settings seems normal.
Today I have installed the driver (Installation CD V1.03) under Windows XP.
Is was mapped to COM7 and I have no problems to connect to EC4. In CoDeSys communication parameters dialog I've selected "Serial(RS232)" with 38400, no parity, 1 stop and flow control off.
Did you follow the installation hints?
- 1st the driver
- then plug in the cable
- 2nd the brigde (comes twice!!!)
 

Roman:
Softwerker59:
Yep, eveything was installed in the correct manner.

Navigation

[0] Themen-Index

[#] Nächste Seite

[*] Vorherige Sete