easy-forum
English Support - Hardware => MFD-Titan® => Thema gestartet von: willypet am Februar 26, 2007, 15:42:44 Nachmittag
-
Hi
I would like to display the actual running time of my machine in h:m:s.The timers limits me to either h:m or m:s.My machine however runs a lot for less than a minute and these time does not getting recorded.I am monitoring it over a 12h period in order to work out my downtime.But the hours does not match.
Thanks
Willy
-
Hi Willy,
MFD has also four up-time counters. They only can display hours (although their internal resolution is higher) but in combination with a timer (m:s) you will be able to display h:m:s.
The up-time counter and the timer should be switched with the same marker bit i.e.
If any questions, don't hesitate to ask.
Kindest regards
Boppel
-
Here is a sample program that uses cascading counters to count seconds, minutes and hours.
The seconds are in MW1, the minutes are in MW2, and the hours in MW3.
Input 1 enables the timing and Input 2 clears the times.
I have not tested the long term accurace of this method...
-
Thanks a million