easy-forum

English Support - Hardware => easy topics (general) => Thema gestartet von: malishhd am September 15, 2005, 10:18:33 Vormittag

Titel: PT01Q1 ????? Please
Beitrag von: malishhd am September 15, 2005, 10:18:33 Vormittag

hi

i had the same problem of snidley ( put & get function block) for updating an analog input from a sensor .
but PT01Q1 never  gets the status 1 . i have done a lot for testing different situations !. even after it has been triggered ?      why ???? ???

Ali

Titel: Re: PT01Q1 ????? Please
Beitrag von: Knodelpa am September 15, 2005, 20:13:09 Nachmittag

Hi,

you need a trigger signal, for example a timer signal.

!--T01Q1------------------------------------------[PT01_T

 :) ;) :D
Paul

Titel: Re: PT01Q1 ????? Please
Beitrag von: malishhd am September 18, 2005, 15:20:30 Nachmittag

Zitat von: Knodelpa am September 15, 2005, 20:13:09 Nachmittag

Hi,

you need a trigger signal, for example a timer signal.

!--T01Q1------------------------------------------[PT01_T

 :) ;) :D
Paul

hi paul

i couldn't do any thing with that .
i didn't understand you exactly
please show me a small example that you make the PT01Q1 get the status 1 .
thanks

ALI 

Titel: Re: PT01Q1 ????? Please
Beitrag von: Tay am Februar 14, 2006, 16:17:15 Nachmittag

USE DE TIMER WITH DE FUNCTION FLASHING WITH PARAMETERS I1 AND I2 0.500 SEGS

REGARDS

ALEJANDRO

Titel: Re: PT01Q1 ????? Please
Beitrag von: KressSwiss am Februar 14, 2006, 17:53:27 Nachmittag

Hi Ali
I wrote an example for you. First let me explain:
In This example the Input Analog I1 from Net ID1 will be sent with PUT to the Net and recived by the NET ID2 with GET. The value is shown on the Easy Display NET ID2.
The PUT Functions Bloc is triggered with the Flash-Timer T01 wich gives every second a Flag to the PUT Functionsbloc. So every second the new value IA1 NET ID1 will be refreshed on the display NET ID2.
Hope you will be sucessful now.
KressSwiss