English Support - Hardware > MFD-Titan®

How to daisy chain MFD?

(1/1)

John_Ess:
I need to run 2 MFD modules connected together...
The first MFD (Display+CP8-NT+MFD-RA17) will be panel mounted on the cabinet door while the second MFD (no display; CP8NT + MFD-RA17 only) will be DIN-rail mounted. 

Will it work if I build such a network using easy NET RJ cable to connect them together?

Maikky:
Dear John.

In general it will work but the MFD is not intended for DIN-rail mounting.
You may use an EASY8xx. Except the visualization (which is not required)
it has the same functionality.

Regards
Maikky

John_Ess:

--- Zitat von: Maikky am März 12, 2014, 21:14:10 Nachmittag ---Dear John.

In general it will work but the MFD is not intended for DIN-rail mounting.

--- Ende Zitat ---

The bare bone MFD CP8-NT has DIN-rail latches that are visible when you remove the display that normally sits on top of it :)

My question was more out of curiosity (or necessity) as I have 2 spare MFD units that I intend to use in one of my projects instead of easy820-DC-RC modules.

Navigation

[0] Themen-Index