easy-forum

English Support - Hardware => MFD-Titan® => Thema gestartet von: malishhd am September 06, 2005, 16:14:49 Nachmittag

Titel: Simulating a Net Project
Beitrag von: malishhd am September 06, 2005, 16:14:49 Nachmittag

Hi

I wander if i can have a simulation when i have a net project and make sure of my work .
Could anybody solve this problem ?

Ali

Titel: Re: Simulating a Net Project
Beitrag von: Runerask am Oktober 11, 2007, 22:38:20 Nachmittag

I use input signal (example I10) then I simulate if the program works. But I havent found something to test the net transfer.

I use to different net-transfer, but so long I only get one of them to work. What could bee wrong?

I use the same code both places, without the number 2 for the second... ::)

Titel: Re: Simulating a Net Project
Beitrag von: KressSwiss am Oktober 12, 2007, 09:32:39 Vormittag

I believe it is possible to test an easy net in the simulation. In the example an input of net ID 2 is switching the output of NET ID 3. (Set or reset the ticker)
(Have a look at appendix)
Hermann