easy-forum
English Support - Hardware => easy topics (general) => Thema gestartet von: tariq_ghuman am Januar 19, 2007, 17:47:12 Nachmittag
-
Hi Guys,
I need help with setting up the EASY819 with a devicenet module. In the devicenet master I am able to see the slave, I am also able to read byte 0 which shows the status of the EASY819. I can see if it in run mode or stop mode etc....however, I am unable to read byte 1. Byte 1 contains the status of the S1-S8 bits. I have attached S1 to S4 as outputs (status) in my ladder program in EASY819 but I am unable to read the status in the master. Am I missing something? I have attached the program below. Please help!
Regards,
Tariq
-
At first: Your easy-program is correct.
At second: Which kind of plc with devicenet master are you in use? How looks your configuration in your plc? S-Data has to be set for input-bits and the R-Data has to be set for the output-bits. Mostly you have to map each byte separate in your configuration.
Ronny