easy-forum
Deutsch - Hardware => Erweiterungen => Kommunikation => Thema gestartet von: jeroengerard am Juli 17, 2008, 20:06:57 Nachmittag
-
does anybody know how I can make my own end registor for my network of an easy822 and mfd module? RJ45 ansluss
and the configuration of the RJ45 cable?
Iam sorry meiner home ist holland
-
does anybody know how I can make my own end registor for my network of an easy822
Have a look at the pictures at the appendix
Is it useable for you?
Hermann
-
pin 1-2-3-4
1-can h
2-can l
3-gnd
4-select cable
1muss an device 2 an 1
2muss an device 2 an 2
3muss an device 2 an 3
4muss an device 2 an 4
die pin pos. hab ich in das hand buch.
ist dass correct?
die wiederstand absluss muss an pin 1 & 2 ?????
danke schon
-
hallo jeroengerard
das ist OK
Gruss Kurt
-
muss die wiederstand zwisschen can-h und gnd und einer zweite wiederstand zwischen can-l und gnd?
oder muss ein wiederstand zwischen can-h und can-l?
die ersten optionen hab ich von ein progammeur von der DIAS- das ist einer plc von die schweis.
danke kurt!
-
Hallo,
der Widerstand von 120 Ohm muss zwischen PIN1 + 2.
:) ;) :D
Gruß Paul
-
danke fur ihre antwoord
-
Die Antwort steht in der anderen Frage! >:( :( ??? ;D
-
Die Antwort steht in der anderen Frage
Wat's the object of this message? I thik the question has been answered.
-
I don´t speak english! ;D
-
Aber wenn Ihr euch ein Patch Kabel holt, Einen 120 Ohm Wiederstand bestellt
seid Ihr teurer dran, wie wenn Ihr gleich einen fertig konfektionierten Abschlußwiederstand von moeller mitbestellt
aber ganz nach dem Motto hauptsache Billig egal was es kostet
-
Da muss Dir ein Komma-Fehler unterlaufen sein! ;D