easy-forum
English Support - Hardware => easy topics (general) => Thema gestartet von: mtkrane am Oktober 09, 2006, 18:47:44 Nachmittag
-
I tried to have the communication between XC200 and MFD, but I Couldn’t.
In Easy Program I Wrote variables R and S, then configured the module EASY221-CO with the function Link..,
In XC200 I decelerated the CAN libraries, and my inputs, outputs variables in the Main Program, but it wasn't enough. ???
Could you tell me how can I have the communication?
I wish I had a sample like a guide.
Thanks
-
Have you tried reading this manual?
ftp://ftp.moeller.net/AUTOMATION/APPLICATION_NOTES/an27k18g.exe (http://ftp://ftp.moeller.net/AUTOMATION/APPLICATION_NOTES/an27k18g.exe)
(link was changed by ronny)
-
Hi
Is this a joke or did you set the wrong link in your message? ??? ??? ???