easy-forum
English Support - Software => OPC Server => Thema gestartet von: Christo am August 03, 2007, 22:56:17 Nachmittag
-
Hi all,
Is there a way to see with easy opc server if a easy relay is in run or stop mode? And if it is posible can you put it in run mode if it is currently in stop mode with?
Regards
Christo Kruger
-
The reason I want to do this is because if the easy is in run mode and I switch off the power and switch it back on again it is in stop mode when it starts. This only stated occurring a week or so ago and I have chaged the program a few times in that period. Will a possible fault in my program cause this? Another thing is that when it starts and is in stop mode I have difficulty getting it to run. The only way to get it to run is by leeting my application connect to it and after that I can manually start it.
What can be the reason for this?
PS. I've attached my program
Regards
Christo Kruger