easy-forum
English Support - Hardware => easy topics (general) => Thema gestartet von: alyou am September 16, 2004, 14:13:36 Nachmittag
-
If my pumps stop and start 20 time a day (10 stops, 10 starts). for a day need to memorise 20 informations, and a week around 120 informations. Is it possible to manage this with a EASY800 or a MFD. If not what is the maximum I can memorise.
-
alyou,
this point is not described in the manual.
For saving time i had a quick simulation with EASY-Soft5.11 using OT.
Users are able to set an OT limit contact like a comparator.
I had done this.
Max allowed value =2147483647
I think this is more than pumps lifetime.
Regards,
Julian
REMARK:
To avoid missunderstanding I attached an EASY-800/MFD memory range table.
For data storing we can't use the hole range,
because a part of them,maybe 10% or less will be needed for the programm itself.
Another reason why not the complete memory is useable ,can you see in the lower memory area.
M,MB,MW,MD uses the same range.
For example:
If we use MB 5 to 8,then we can't use MW 3,4 and DW 2 at the same time.
But I think there is enough memory available.