easy-forum
English Support - Hardware => MFD-Titan® => Thema gestartet von: tommyrush am Februar 06, 2005, 12:28:59 Nachmittag
-
Hi there
Im looking for some Help! Does any one have an example for a pump change over circuit?
I have 2 pumps that i have to control.
(Pump Selection )
I1 = Pump 1 - Pump 2
I2 = Pump 2 - Pump1
If the overload or the flow switch failes(I4) it will select the next pump after a delay of 1min. When a reset button is pressed (I3) it wll change back over on to the lead pump that is selected via the switch (I1 or I2).
Regards
Tommy
-
Tommy,
see my attached example.Easy-Soft V 5.11pro.
I use two jumps.That works in conjunction with I01 and I02 like a program selector switch.
May be it can serve as a basic for your application.
Regards,
Julian
-
Julian
Thanks for the application you sent, works very well. ;D
thanks again
Tommy Rush