easy-forum
English Support - Hardware => MFD-Titan® => Thema gestartet von: antik88 am Mai 10, 2009, 19:34:17 Nachmittag
-
I am new to Moeller equipment and would appreciate any advice / assistance regarding my application.
I have a MFD Titan + 2 x Easy 819 units. I will be using a total of 20 inputs for this application.
Each of the 20 inputs need to be assigned a numerical value which should be displayed on the MFD Titan when the input is activated. For example, if input 1 is "on", then I need the display to indicate 150 m3/h. If input 2 is activated, I need the display to indicate 230 m3/h. Each of the 20 inputs will be assigned a different value as above.
If input 1 and 2 are activated simultaneously, I need the display to show "380 m3/h". There are quite a few different combinations as there are 20 inputs which could be "on" or "off" in no specific order.
I can't seem to get the calculation to work properly, so I'm no longer sure if the above would even be possible!
I would appreciate any advice you are able to provide regarding the above.
Thanks and Regards,
David
-
Guten Tag antik88,
one way to display your FLOW METER. In the simulation it works good. May be it is ok for you.
short manuel:
Flow meter is the first display (Startmaske) and show the sum of flow.
Button right : jump to Parameter I1
Button down : jump to input field-parameter-I1
Button right, up, left and down for input parameter (150m³/h)
Button : OK = parameter ready
Button right : jump to next parameter display (I2, I3, I4, ... I20)
Button ESC : back to display FLOW METER
All parameters are saved !
Mit freundlichen Grüssen
Fricke
-
Good Afternoon Fricke,
Thanks for your help! This is exactly what I require.
My hardware configuration is slightly different, however I guess I can remove a few of the items and use them on the next project.
Your assistance is highly appreciated.
Best Regards,
David