easy-forum

English Support - Software => easySoft => Thema gestartet von: AcmeMan am Januar 02, 2008, 20:32:42 Nachmittag

Titel: Send signal in an easy net
Beitrag von: AcmeMan am Januar 02, 2008, 20:32:42 Nachmittag

Hi
how i could close a contact in a device using  a coil from another device in the same net?
Greetings

Titel: Re: Send signal in an easy net
Beitrag von: KressSwiss am Januar 02, 2008, 21:52:10 Nachmittag

Hi
Use SN (Send) and RN (Recive)
Device 1 will send by SN Input 01 to the Easy-Net
The Device 2 will recive the signal by RN and is connectet with Q0
(SN and RN has to have the same number)

Have a look at the ScreenShot at the appendix. More questions? Don't hesitate to ask.

Titel: Re: Send signal in an easy net
Beitrag von: AcmeMan am Januar 02, 2008, 22:24:44 Nachmittag

Does simulator work with this signals?

Titel: Re: Send signal in an easy net
Beitrag von: KressSwiss am Januar 02, 2008, 22:33:08 Nachmittag

Not really
But it is possible to activate RN by setting a ticker in the simulation. So you have a reduced opurtinity to simulate the Programm in Device 2.
Hermann

Appendix:
Device 2 1RN01 activated by setting a ticker