easy-forum
English Support - Hardware => MFD-Titan® => Thema gestartet von: amino am Juli 14, 2005, 10:32:04 Vormittag
-
would you please give me a simple example how to acitvate bitmap display , i mean how can we use in automation... thanks
-
If you have EASY-SOFT Pro installed you will find examples on your hard disc:
C:\Program Files\Moeller Software\EASY-SOFT 6 Pro\Samples
if not you can find attached the mfd samples.
-
I too did not have the samples referred to in the manual.
I downloaded the example zip above, but when I try to open them I get an error "this project contains an unsupported device"
This is frustrating.
I have Easy-Soft 5.01 pro and 6.10 basic installed.
Any ideas?
Or could someone post an example of how to use a screen to enter a speed and then transfer this to the analog output, a simple recipe type program is what I'm really after.
Prog1 constant speed set by up/down buttons
Prog2 2 speeds and a counter, speed 1 - normal, when count is reached speed 2 for 1 second, reset count.
Prog 3 as above etc to Prog 8
TIA
RevJim