easy-forum

English Support - Software => easySoft => Thema gestartet von: bendo am April 15, 2009, 21:12:10 Nachmittag

Titel: Multi-simulation
Beitrag von: bendo am April 15, 2009, 21:12:10 Nachmittag

Hi

It is possible to use EasySoft Pro to simulate a project with more than one  Device in same time


my best regards

Titel: Re: Multi-simulation
Beitrag von: KressSwiss am April 16, 2009, 21:46:02 Nachmittag

 :(
Unfortunately no. It isn't possible. Either Master-Master nor Master-Slave Connection.

Regards
KressSwiss

Titel: Re: Multi-simulation
Beitrag von: KressSwiss am April 18, 2009, 17:34:02 Nachmittag

Hi bendo
I have a gleam of hope for you. Not in the Simulation. But if there is a Easy-Net, and the Program has been transferred into the Net-Members, you can plug the Program-Cable into any of the Net-Members. And up to this Point you can have a look into al the other Net-Members. It means, it isn't necessary to change the Plug.

Regards
KressSwiss