easy-forum

English Support - Hardware => MFD-Titan® => Thema gestartet von: MSB am Mai 02, 2006, 18:05:31 Nachmittag

Titel: COM-LINK
Beitrag von: MSB am Mai 02, 2006, 18:05:31 Nachmittag

COM-LINK OR EASY-NET? WHEN I CHOOSE ONE OR ANOTHER?

Titel: Re: COM-LINK
Beitrag von: KressSwiss am Mai 07, 2006, 20:38:36 Nachmittag

Hi MSB

COM-LINK OR EASY-NET? WHEN I CHOOSE ONE OR ANOTHER?

I’m not sure if I understand jour question. Do you mean when its better to use Com-Link and when Easy-Net?.
If you has an Easy 800 (500) into a panel and you would like to handle it from the outside (in Ftont of the Panel) use a MFD-80 connected by Com-Link. (MFD-CP4-800 (500)). It’s a competitiv solution because you don’t need an MFD-CP8-NT.
If you will use the whole performance of an MFD (Graphics, Bitmaps et cetera) you need a connection between EASY 800 (500) and
MFD-CP8-NT by Easy-Net.
Don’t hesitate to ask if you need more information.
Hermann
 

Titel: Re: COM-LINK
Beitrag von: MSB am Mai 11, 2006, 23:15:04 Nachmittag

In the page 288 of the easy mfd titan manual show a grafic with a four easy in easy-net and two in a com-link conection. My question is:

Is not the same this configuration with all the easy in a easy-net conection

Titel: Re: COM-LINK
Beitrag von: KressSwiss am Mai 12, 2006, 22:05:32 Nachmittag

Hi
Com link is a point to point connection and givs the possibility to read states of  Inputs and outputs of EASY- or MFD-units. It is also possible to read and write into a aerea of the merker field. It has nothing to do with Easy Net. It will be used for special applications. I never used it an I’ve no experience.
Hermann   

Titel: Re: COM-LINK
Beitrag von: MSB am Mai 14, 2006, 15:40:25 Nachmittag

Ok.

Thanks for the replys

MSB