easy-forum
English Support - Software => easySoft => Thema gestartet von: Dino am Juni 29, 2009, 13:51:12 Nachmittag
-
I have an mfd and an mfd-tap13-pt-b, i want to be able to run a heater via an anologue output which after a while will reach a certain setpoint via analogue input 1 which is connected to a pt100 sensor. When it has reached the setpiont it needs to stay at it for 10secs then stop. Anybody able to help please.
-
When it has reached the setpiont .........
Hi
An additional question. Is this setpoint fix or is it manually adjustable?
Regards
KressSwiss
-
If it could be adjustable that would be great.
-
Hi Dino
I have to travel away for some days. I’ hope somebody else is in the reason to help you.
Regards
KressSwiss