Display Alarms

[adaly]

Hi every body,

I have MFD-80-B + MFD-CP8-ME + MFD-T16. I need some assistance to display at least 4 alarms.  These can appears alone or at the same time. If there more than one active, I like that the windows switch between them like they do in the esay600 with the function “D – Text Display”. Has to be self-reset and in I press a button this just acknowledge the one that is active.

Thanks in advance. 

[Bluebello]

Hallo adaly!

That is no more Problem using rolling masks. All active Masks are changed in a 4 sechonds cycle.

[KressSwiss]

Hi Adaly
Have a small Demoprogramm for you. Four defaults will be shown by MFD Display.
I1 = Emergency Stop
I2 = Oil Temp high
I3 = Motor Overload
I4 = Stock Empty
I used rolling Text controlled by MW1. Every defaults which are actuated are shown in circel of four seconds.
Hafe fun
Hermann

[adaly]

Hi Adaly
Have a small Demoprogramm for you. Four defaults will be shown by MFD Display.
I1 = Emergency Stop
I2 = Oil Temp high
I3 = Motor Overload
I4 = Stock Empty
I used rolling Text controlled by MW1. Every defaults which are actuated are shown in circel of four seconds.
Hafe fun
Hermann

Thanks Hermann,

This might help, when I finish the project I'll share the result for further sample.

Question, is possible open a forum section in spanish? I like to share my experience with other spanish spiking people.

[MSB]

i like to know how you asign a each input the alarm display in the rolling text?

[Bluebello]

Hallo MSB!

you have to wire each input to a marker of the same MB (or MW, if you need)

e.g. I1 to M9, I2 to M10...

Then you select "roll masks" in the last card of "Visualisation". I don'k know the exact englisch designation. It should be something like "Mask control"

Then you select your specified MB and select a Mask for every bit.

cu
Hans