Hello
I would like to use easycontrol's rs232 (com1) in transparent mode (I want to send and receive messages to gsm modem)
below is my code:
IF uchwyt=0 THEN
uchwyt:=SysComOpen(Port:=Com1);
END_IF
typComSettings.typPort:=1;
typComSettings.typBaudRate:=baud_38400;
typComSettings.typParity:=0;
typComSettings.typStopBits:=0;
res:=SysComSetSettings(uchwyt,ADR(typComSettings));
IF res=1 THEN
IF c=0 THEN
SysComWrite(uchwyt,ADR(dozapisu),5,0);
c:=1;
END_IF
END_IF
IF c=1 THEN
b:=SysComRead(uchwyt,ADR(odczyt),3,0);
END_IF
dozapisu:dword:='abc';
writing are working without problem (I connect PC terminal and see this text)
When I send word "abc" to easycontrol I allways receive only 1 byte (though in command syscomread are 3 bytes)
sometimes receive "a", sometimes "b".
I try to set various value (3, 5, 15). I allways receive 1 byte.
I try to set various value of time (in command above i "0"), but it still receive 1 byte.
Any ideas?
Lukasz
