easy512-dc-rc version

[Nassos]

I am using easysoft-pro v6.93 and trying to programm an easy512-dc-rc....

I have two problems:

a) My device is version 08 which is not supported (there is only 01 and 10)
b) The simulation seems to be bugged and some times chooses not to set an output or a timing relay. I attach a screenshot as well!

Thank in advance!

[Urs]

Hi Nassos
Did you used the plausibility check before starting simulation?

If I am right you have used the coils several times. One coil can only be used once.

If you are using analog inputs they can't be used as binary inputs as well (either or).


I don't know what the Ax NO and NC contacts are used for, should this be digital inputs? Digital Inputs are usually I1 ... I12.

If your Hardware has version 8 and the Software only offers 1 or 10, then you have to choose Version 1.

Regards

Urs

[Nassos]

Thank you very much Urs!

I will use version 1 then.

Regarding the coils...it is certainly a bug.
It was working before and I didn't change anything. Ity just stopped working. And now, I just changed the arrangement of the logic (removed the coil branch to another position) and it runs again....