Hello Horst,
With here the complete program
The problem is that the 3 counters in the consumption menu must be reset by pressing Del.
Also I can not get one alarm screen you see, have now made an overlay screen for it.
But this is not handy
, maybe you know how this works, because when I activate the alarm
screen it come not back to the original screen.
Project description:
2 conductivity meters in 2 baths, and 5 pumps, 1 switch to switch between low and high concentration
P1 runs in 100 % at the conductivity I1 analog
P2 runs on P1 (interlock between them) in menu only give the ratio (settings_2)
P3 runs in 100 % at the conductivity I2 analog
P4 runs on P3 (interlock between them) in menu only give the ratio (settings_2)
P5 runs on P1 with ratio given in menu (settings_2)
P5 can also run on batch mode give the amount of liters and it's runs.
Also conductivity in bath 1 can be conductivity in bath 2 so SP1 = SP2 on that moment
Screens:
Actual_1 -> Actual values on the concentration in bath 1 and 2
Actual_2 -> SP1 and SP2 in low and High Concentration bath 1 and 2
Consumption -> total consumption prod1, prod2, prod3. (del = reset -> don't work)
Settings_1 -> pump capacity for pump 1, 3, 5
Settings_2 -> ratio pump 2, 4, 5 on pump 1 and 2
Settings_3 -> Setpoint bath 1 = Setpoint bath 2
Settings_4 -> Max dosing time, time before dosing, time before empty alarm
Batch -> Batch for pump5 (prod3)
Alarm -> Alarms.
With regards,
Martijn