Easysoft 5.02 Activate P-buttons

[William van Melis]

How can I activate the P-buttons on MFD80B with Easy ?
Help function says in properties screen, but where ?

Further in Button editor with OK button, what means the function Change Over Relay

Does it mean that if I configure M25 and I press OK button the M25 changes from 0 to 1 (if it was 0) and if it was 1, changes from 1 to 0 ??

I use the MFD to check additional machine alarms. If there is no alarm, the backlight is switched off. If there is an alarm (by input) then I activate the backlight (and certain mask). This is working well, but I want the activate the backlight also if some presses OK button.

Please help me.

Thank you in advance,

William

[julian]

William,
unfortunately I don't have the English EASY-Soft version,
but I think description is similar to the German one.

To Question1
-Go to projekt.
-Click one time MFD symbol.
-Open system menue (lower screen area).
-Set a mark to P-buttons(lower screen area left side).

To Question2
-You are right with your meaning about OK button.
-Function is like a toggle switch.

To Question3
For example:
-Create in button editor a connection between marker No.10 and OK button.                                        
-Create a AND logic with your alarm inputs and M10/inverted.
-If a alarm input occurs you can toggle with Ok button LED1(backlight) ON/OFF.
Why M10 inverted?
After EASY start M10 is not in set position.
Regards,
Julian

[julian]

Answer correction
William,
unfortunately I don't have the English EASY-Soft version,
but I think description is similar to the German one.

To Question1
-Go to projekt.
-Click one time MFD symbol.
-Open system menue (lower screen area).
-Set a mark to P-buttons(lower screen area left side).

To Question2
-You are right with your meaning about Change Over Relay/ OK button.
-Function is like a toggle switch.

To Question3
For example:
-Create in button editor/Change Over Relay a connection between marker No.10 and OK button.                                        
-Create an AND logic with your alarm inputs and M10/inverted.
-If no alarm input occurs you can toggle with Ok button LED1(backlight) ON/OFF.
Why M10 inverted?
After EASY start M10 is not in set position.
Regards,
Julian