Easy822 program

[Spellbreaker]

Which Version of Easy-Soft are you using?

Here's a screenshot where Q1 is Active. I activate I10 and then Q2->on, Q2->off, Q1->on, Q1->off.

[Maikky]

Dear Pjotr.

You can also see it quite nice in the oscilloscope.

Attached please find a screenshot
channel #1 : I10
            #2 : Q2
            #3 : Q1

Regards
Maikky

[Pjotr]

Hi Maikky,

I've that all done before but like told the Q1 output would not be activated.
There must be a flag settled to error condition after the short circuit of
Q1 and Q2. But the question are how to reset that error flag

grtz
pjotr

[weiss_nix]

hi pjotr,
i think the q1 and po01 in line 152 won't work in cooperation! i've deleted line 152 and the simulation works fine!
regards

[weiss_nix]

hi again,
have a look at the symbol in the atachment, it tells you some information about wrong code!
regards

[Pjotr]

Hi Weise_nix,

you gat that  the problem right on it.
I delete that line to in MHC and the Q1 are back to live.
Thanks a lot helping me struggling out with that Q1 issue.
But I don't understand what's the realtionship between
both operands. Maybe some explanation help me and some
other forum users on our way.
regards

[weiss_nix]

hi pjotr,
po01,po02 is a programmable pulse-output to q1,q2 and have a higher priority in the circuit! have a look to the helpfile in your easysoft by pressing f1, there are a lot more infos about the po's
regards