COM-LINK

[MSB]

COM-LINK OR EASY-NET? WHEN I CHOOSE ONE OR ANOTHER?

[KressSwiss]

Hi MSB

COM-LINK OR EASY-NET? WHEN I CHOOSE ONE OR ANOTHER?

I’m not sure if I understand jour question. Do you mean when its better to use Com-Link and when Easy-Net?.
If you has an Easy 800 (500) into a panel and you would like to handle it from the outside (in Ftont of the Panel) use a MFD-80 connected by Com-Link. (MFD-CP4-800 (500)). It’s a competitiv solution because you don’t need an MFD-CP8-NT.
If you will use the whole performance of an MFD (Graphics, Bitmaps et cetera) you need a connection between EASY 800 (500) and
MFD-CP8-NT by Easy-Net.
Don’t hesitate to ask if you need more information.
Hermann
 

[MSB]

In the page 288 of the easy mfd titan manual show a grafic with a four easy in easy-net and two in a com-link conection. My question is:

Is not the same this configuration with all the easy in a easy-net conection

[KressSwiss]

Hi
Com link is a point to point connection and givs the possibility to read states of  Inputs and outputs of EASY- or MFD-units. It is also possible to read and write into a aerea of the merker field. It has nothing to do with Easy Net. It will be used for special applications. I never used it an I’ve no experience.
Hermann   

[MSB]

Ok.

Thanks for the replys

MSB