Displaying calculated value on MFD Titan

[antik88]

I am new to Moeller equipment and would appreciate any advice / assistance regarding my application.

I have a MFD Titan + 2 x Easy 819 units. I will be using a total of 20 inputs for this application.

Each of the 20 inputs need to be assigned a numerical value which should be displayed on the MFD Titan when the input is activated. For example, if input 1 is "on", then I need the display to indicate 150 m3/h. If input 2 is activated, I need the display to indicate 230 m3/h. Each of the 20 inputs will be assigned a different value as above.

If input 1 and 2 are activated simultaneously, I need the display to show "380 m3/h". There are quite a few different combinations as there are 20 inputs which could be "on" or "off" in no specific order.

I can't seem to get the calculation to work properly, so I'm no longer sure if the above would even be possible!

I would appreciate any advice you are able to provide regarding the above.

Thanks and Regards,
David

[Fricke]

Guten Tag antik88,

one way to display your FLOW METER. In the simulation it works good. May be it is ok for you.

short manuel:

Flow meter is the first display (Startmaske) and show the sum of flow.

Button right   :   jump to Parameter I1
Button down : jump to input field-parameter-I1
Button right, up, left and down for input parameter (150m³/h)
Button           : OK = parameter ready
Button right   : jump to next parameter display (I2, I3, I4, ... I20)
Button ESC    : back to display FLOW METER

All parameters are saved !


Mit freundlichen Grüssen

Fricke
           

[antik88]

Good Afternoon Fricke,

Thanks for your help! This is exactly what I require.

My hardware configuration is slightly different, however I guess I can remove a few of the items and use them on the next project.

Your assistance is highly appreciated.

Best Regards,

David