I have a project to go at using an mfd and a mfd-tap13-pt-b, using a pt100 as the heat sensor i would like to use a button on the mfd as the start of the cycle it would then start a heater1 using analogue output, when it has reached a set temp it will remain at that temp for 15secs, it will then switch off and open a solenoid for a set period of time, when this has timed out it will bring on heater2 which will then reach a set temp tirn off and bring heater1 back on to reach a higher temp for a set period of time. I am using IA1 for the pt100 and i have a guard on I01 which must be closed before the cycle can start. On the screen i would like to show the current temp and some for of cycle count as it is operating. Also would it be possible to have another screen set up where i can change to perameters of the heaters and timers instead of going into the main menu and changing them in the program.
