easy 821 DC -TCX +620-Dc-Te + mfd CP4 +MFD-80-B

[Juga]

Hi ,

 I have a easy 821 DC -TCX +620-Dc-Te + mfd CP4 +MFD-80-B
but when i connect the mfd-80-B into the 821dc-TCX the screen says connection in progress ,please wait.
Can someone please help me out with this,do i have to make a setting or what do i did wrong?
Can someone please have me an example?

Many thanks ,

Jürgen

[Maikky]

Dear Jürgen.

A permanent message "connection in progress" indicates, that the connection between CP4
and Easy 821 can not be established.

At first you should double check the wire connection at the CP4 acc. to attached diagram.

Regards
Maikky

   

[Juga]

Hi Maikky,

Thanks for you're fast response.
I checked the wirrings and they are correct fitted.
What can i do now???

many thanks,

Jürgen

[Maikky]

Dear Jürgen.

I never used the CP4 by myself so the next hint is more or less a guess. 

The CP4 is using the serial interface for connection and the max. baud rate is 19200 for
Easy8xx series. In case you are using the connection to EasySoft with a higher baud rate
during program transfer it may be worth a try to slow down the connection before re-connecting
the CP4.

Regards
Maikky

 

[miriw]

Hello,

I have the same problem . Did you found already the solution ??

I am waiting for your response please.

Best regards
Wajih