easy e4 12tc1

[magdziar]

what to do to make the Q01 coil work with two buttons?
the buttons should be secured against pinching (they will work in different lines of the program). At this point, the signal from the I01 button does not come out, but I02 is working properly

[Juergen]

Was tun, damit die Q01-Spule mit zwei Tasten funktioniert?
Die Tasten sollten gegen Einklemmen gesichert sein (sie funktionieren in verschiedenen Programmzeilen). Zu diesem Zeitpunkt wird das Signal von der I01-Taste nicht ausgegeben, aber I02 funktioniert ordnungsgemäß

Hello, a Contactor coil may only be assigned once, unlike an S, R

I did not understand the task 100%.
See my solution in the picture


If a sticking button is to be recognized and the other button continues to function, a timer would be a solution.
Make an exact functional description
Soll ein Klemmender Taster erkannt werden und der andere Taster weiter Funktionieren, wäre ein Timer eine Lösung.
Mach mal eine genaue Funktionsbeschreibung

[magdziar]

that's what I meant, thank you

[Juergen]

Is my solution in the picture OK or a timer monitoring

[magdziar]

Nadal potrzebuję tego jak wciskam przycisk I01 żeby dać sygnał do Q01 ale przycisk S02 nie daje sygnału i odwrotnie

[magdziar]

[Juergen]

That fulfills the solution in my picture

XOR

[magdziar]

yes, but partially when I press the I01 button it is supposed to work only from one program line, not two

[Juergen]

yes, but partially when I press the I01 button it is supposed to work only from one program line, not two

Why a 2 program line?
One fulfills the requirement.
Otherwise you have to work with a marker

[magdziar]

when I have an xor function in every line of the program I have outputs working independently of the button



I made a working program, but only in the simulation when I press the button and only 2 lines of the program work (it must be) of course the i01 button does not come out, and the i02 works properly


I have a contactor SD (DOWN) and SG (UP) when I press the i01 (UP) button, the S01 and S02 contactors switch on after 1 second, the program has separate  of potentiometer values for ​​(UP) and (DOWN)

[magdziar]

can i send you this program and you will check what i nust fix to work?

[weiss_nix]

hello magdziar,

maybee the attachment can help?!?

[Juergen]

Hello,
the "contactor" function may only be used once as an output in the program. Only once Q1 and Q2 as a coil contactor.
See pictures
With the function S, R, current impulse also several times.


Attach the program as a zip file

[magdziar]

https://www17.zippyshare.com/v/CvVKrRNH/file.html line 0005  0006  0009  0010  0016  0017 0020  0021

[Juergen]

Attach the program as a zip file
Here directly in the forum! See 3 picture last post from me