Greenhouse Automation

[Ronaldvm]

Hi,
Im am new to the subject but got interested in the Easy 800 with the following project in mind.
My parants own a small greenhouse (500m2) and the heating/ventilation/watering is done with analogue PID controllers. These controllers are more than 10 yrs old and spareparts are hard to find.
I would like to replace them by one Easy 800.
These are the IO's
IN
1-Temperature (analogue)
2-Window angle (analogue)
3-Water temperature (analogue)
4-Vertilization % of the water (analogue)
OUT
1-start/stop waterpump
2-open window
3-close window
4-start/stop heating
5-open valve water 1(normalle closed)
6-open valve water 2(normalle closed)
7-open/close 3-way valve heating circuit (analogue ?)
8-warning signal

I have downloaded and read the manual and so far this application appears to be possible. But I would like to be able to change the setpoint for temperature and running time for pump directly on the panel.
Can this be done or is it more easy to use a pot meter for input ?

[julian]

You can change settings by using EASY buttons.
A detailled description is part of EASY-Soft online help.
Regards,
Julian 

[Ronaldvm]

You can change settings by using EASY buttons.
A detailled description is part of EASY-Soft online help.
Regards,
Julian 

From what i understoon from the manual it is possible to change the program with the Easy button, but this is to diffucult when you want to change temperature settings frequently.

Can I program the Easy buttons so that pressing the up/down arrow increases/decreases temperature by 1 degree ?

[julian]

Yes this is possible also.
Do you have Easy-Soft?
If yes,which version?
I can support you with an example pressing UP(P2) and DOWN(P4) button increasing/decreasing Temp. limits by one degree.
Regard,
Julian